This is a magnetically driven type proximity switch which uses a magneto resistive element.
This is a proximity switch that operates by magnetic force. The simple drive method realizes low cost.
The operating distance can be set by magnetic force with this proximity switch, and custom-made products are also available, such as changing the length of the wires, or the terminal processing, etc.
- - Adopted a magneto resistive element
- - Magnet drive type
- - Can be semi-permanently by semiconductor output
- - Built-in surge absorbing circuit and power supply polarity protection circuit
- - Operating distance can be set by a magnet
* Adobe Reader is required to open a PDF file.
|Configuration||Cylindrical type||Square *1|
|Power supply voltage||DC10V～30V *2||DC10V～30V *2|
|NO (Normally open) type||NON－F2||NON－F2|
|NC (Normally closed) type||－||NCN－T2|
|Standard operating distance||10mm|
|Hysteresis||0.5 mm or less|
|Standard detection object||JM－102||JM－104|
|Operating distance||Product variation||Less than ±2 mm of standard operating distance|
|Temperature characteristics||- Temperature range from -20 to 70 º C, less than ±20% at 20 ºC|
|Voltage characteristics||Voltage range from DC10V to 30V, less than ±20% at 20V|
|Case Material||Case: Heat-resistant ABS
Thread portion: SPCC
|Heat resistance: ABS|
|Output method||NPN open collector|
|Output power supply voltage||DC5～10V||DC10～30V|
|Maximum output current||100mA(5V)
|Residual voltage||0.6V or less|
|Operation configuration||NO When detection object approaches Load ON
NC When detection object approaches Load OFF
|Display method||NO When detection object approaches LED lighting
NC When detection object approaches LED turning off
|Maximum switching frequency||1000Hz|
|Insulation resistance||100MΩ or more|
|Withstand voltage||AC1500Vrms / For 1 minute|
|Operating temperature range||-20～70℃|
*1 The detection surface of the square type changes according to the operation method (Front F / Top T).
*2 A power supply voltage of DC5 to 10V type is also available. The "1" at the end of the model number (Ex.: JME-001 NON-F1)